Filter Maintenance - IPC Gansow 1010 E Manual De Instrucciones

ALL ROUNTINE MAINTENANCE AND SPECIAL MAINTENANCE MUST BE CARRIED OUT BY COMPETENT PERSONNEL OR BY
AN AUTHORISED SERVICE CENTRE.ALWAYS USE ORIGINAL SPARE PARTS.ALL MAINTENANCE OPERATIONS MUST BE
CARRIED OUT WITH THE MACHINE OFF.
C O N T R O L L I
Controllare liquido batteria
Controllare l'usura delle cinghie
Registrare il freno
Controllare il serraggio di dadi e viti
Controllare lo stato delle spazzole
Controllare la tenuta delle guarnizioni
Controllare il funzionamento di tutte le funzioni
Ingrassare la catena dello sterzo
The life of the battery will depend on its routine maintenance and on
its discharge level.
Do not allow the battery charge to drop below the limit signalled by
indicator light (H Fig.3).
Charge indicator lights
GREEN LIGHT:
YELLOW LIGHT:
rge as soon as possible.
RED LIGHT:the battery has run out. DO NOT
operate the machine.
Every 200 hours of work,check the state of the motor carbon brushes
of every electrical motor and replace them if they are worn.
Always try to replace them before they reach 1000 hours of work.
7.1BATTERY MAINTENANCE The battery must
be kept clean and dry. Keep the terminals and poles
clean.
Every 10 hours,remove the caps and check the electrolyte
level. If necessary top up with distilled water.
The battery should be serviced in a properly ventilated area. During
this operation,do not expose the battery to naked flames and do not
smoke.
The battery has a 4 hours working life;if you notice that it is much
shorter,check that:
* the brushes are not obstructed.
* the battery is completely charged before starting the work.
ENGLISH (Translation of original instructions)
- ROUNTINE MAINTENANCE -
Check the battery liquid
The belts for slackening
Adjust the brake's cable
The tightness of nuts and screws
The brushes for wear
The gaskets for wear and leakages
If all the functions are in working order
Grase the steering chain up
the battery is fully charged.
the battery is running out, recha-
C H E C K

7.2 - FILTER MAINTENANCE

The filter is a component of primary importance for the correct work of
the machine.Its correct maintenance will keep the functioning of the
machine always to the highest levels.
The filter can be cleaned in two ways:
1 - The electric filter shaker
This instrument is simple to use and allows you to keep the filter in
perfect working order. To operate the shaker, push down the switch
2, fig. 3 and hold it down for a few seconds. Repeat the operation 4 or
5 times.Remember that the cleaner the filter, the better the results.
This operation should be carried out after every work cycle.
DUSTY ENVIRONMENT:If you are using the
machine in a particularly dusty environment ( i.e.
warehouses with trucks passing, sawmills, ecc...
remember that the filtershaker should be used more
frequently.
2. Cleaning the filter manually
In the case in which the cleaning of the filter by the filter-shaker
wouldn't be effective,and every 20 working hours anyway,proceed
with the manual cleaning of the filter.
Before carrying out every operation on the machine,make sure that this
last be switched off and that all of its functions be disactivated,to get
to this state, set the key switch 3 Fig.3 in the OFF position.
1 - Lift the bonnet where the seat is located.
2 - Slacken the wing nut on the filter box cover.
3 - Remove the cover.
Clean the filter blowing with a jet of compressed air directed towards
the waste bin, so that any residual falls into the bin.
x x
x
x
x
x
x
x x
x
Pag. 7