Attaching The Bar, Chain And Chain Brake - Oregon JW3800 Operación Manual

Attaching the Bar , chain and chain brake to the
engine
Carefully remove the chain from the bag and
spread it out on a flat surface.
Before continuing note the directional arrow on
the chain link, once attached to the chain bar
this arrow should be pointing away from the
main unit along the top of the bar, and towards
the unit along the bottom of the chain bar. The
chain bar also shows the direction of travel for
the chain (see fig 1.)
The chain should now be attached to the
drive cog that is located beneath the
flywheel.
Place the Chain Bar onto the main unit at an
angle over the two locating studs and carefully
push the Chain into the groove around the
edge of the bar, once the chain is in place along
the top of the Chain, gently pull the chain bar
away from the main unit, this will relieve some
of the slack on the chain allowing you to push it
in place along the bottom of the bar.
7