Operating Components - Ryobi RTS31 Manual De Operación

OPERATING COMPONENTS

The upper portion of the blade projects up through the table
and is surrounded by an insert called the throat plate. The
height of the blade is set with a handwheel on the front of the
cabinet. Detailed instructions are provided in the Operation
section of this manual for the basic cuts: cross cuts, miter
cuts, bevel cuts, and compound cuts.
The sliding miter table assembly is used for cross cutting
operations. The miter fence is easily adjusted to cut wood
at an angle by loosening the adjusting clamp, setting the
fence to the miter scale, and retightening the clamp. With
the miter fence removed, the miter table offers additional
support for other operations such as ripping.
The rip fence is used to position work for lengthwise cuts.
A scale on the front rail shows the distance between the rip
fence and the blade.
It is very important to use the blade guard assembly for
all through-sawing operations. The blade guard assembly
includes: riving knife, anti-kickback pawls, and plastic blade
guard.
SWITCH ASSEMBLY
See Figure 3.
This saw is equipped with a switch assembly that has a
built-in locking feature. This feature is intended to prevent
unauthorized and possible hazardous use by children and
others.
TO TURN YOUR SAW ON:
 With the switch key inserted into the switch, lift the switch
to turn ON ( l ).
TO TURN YOUR SAW OFF:
 Press the switch down to turn OFF ( O ).
TO LOCK YOUR SAW:
 Press the switch down.
 Remove the switch key from the switch and store in a
safe, secure location.
FEATURES
WARNING:
Always remove the switch key when the tool is not in
use and keep it in a safe place. In the event of a power
failure, turn the switch OFF ( O ) and remove the key.
This action will prevent the tool from accidentally starting
when power returns.
WARNING:
ALWAYS make sure your workpiece is not in contact with
the blade before operating the switch to start the tool.
Failure to heed this warning may cause the workpiece to
be kicked back toward the operator and result in serious
personal injury.
WARNING:
To reduce the risk of accidental starting, ALWAYS make
sure the switch is in the OFF ( O ) position before plug-
ging tool into the power source.
SWITCH KEY
SWITCH IN LOCKED POSITION
11
SWITCH
SWITCH
ON
OFF
Fig. 3