Pioneer VSX-D712-S Manual De Instrucciones página 15

Quick surround sound setup
• ERR Fch – Check the front speaker
connections.
• ERR Sch – Check the surround or
surround back speaker connections.
• ERR SW – Make sure the subwoofer has
been switched on and volume on the
subwoofer is turned up.
7 Use and to select the speaker
system that corresponds to your setup.
Cycle between the following choices:
2.0ch 2.1ch*
7.1ch*
7.0ch
6.1ch* 6.0ch
* Indicates a subwoofer is included in your
speaker setup
See the table on page 12 if you're unsure
which speaker system to select.
8 If you selected a speaker system that
includes a subwoofer, press ENTER to
check the subwoofer output level.
If the subwoofer output level is too high/low,
SW.VOL.UP/SW.VOL.DWN blinks in the
display for five seconds. To exit and check
your subwoofer output level, press MCACC
SETUP (see the notes regarding noise levels
below) or simply turn the subwoofer volume
up or down (as indicated), then press ENTER
when you're prompted to GO NEXT?
9 Press ENTER to finish the auto
surround setup.
The system checks for speaker size, channel
delay and channel level. If you have
connected a subwoofer, it will check for
ambient noise once again.
When the auto surround setup is complete,
the volume level returns to normal and
COMPLETE, then RESUME shows in the
display.
All manuals and user guides at all-guides.com
3.0ch 3.1ch*
4.0ch
4.1ch*
5.1ch* 5.0ch
• If the room environment is not optimal for
the auto surround setup (too much
ambient noise, echo off the walls, obsta-
cles blocking the speakers from the
microphone) the final settings may be
incorrect. Check for household appli-
ances (air conditioner, fridge, fan, etc.),
that may be affecting the environment
and switch them off if necessary.
• Some older TVs may interfere with the
operation of the mic. If this seems to be
happening, switch off the TV when doing
the auto surround setup.
• Using the MCACC system to set up your
speaker system overwrites any previous
settings you had for the STANDARD or
ADVANCED SURROUND modes.
• When the STANDARD or ADVANCED
SURROUND mode is selected, you can
check the settings made with MCACC by
using CH SELECT (to check channel
levels) or by going through the steps in
Choosing your receiver setup on page 43
to check other settings.
• Depending on the the characteristics of
your room, sometimes identical speakers
with cone sizes of around 12cm will end
up with different size settings. You can
correct the setting manually using the
receiver setup on page 43.
03
15
En