Tabla de contenido
PROBLEMS
Excessive noise during
operation
the bowl or from the XL
base accessory.
The blades do not ro-
tate easily.
Smell from motor.
+ red indicator light is
Display "Err8"
+ red indicator light is
+ red indicator light is
CAUSES
The use of a wrong accessory
Volume of ingredients too high.
The lid is not correctly positioned or
The lid seal is not present.
The lid seal is cut or damaged.
Accessory error.
The bowl seal (D4) is not correctly po-
sitioned.
The bowl seal is damaged.
(D7)
correctly.
Pieces of food that are too big or too
hard.
or in the event of overload of the motor
caused by too large a quantity of ingre-
dients or by pieces that are too hard or
too big.
The appliance has detected too many
vibrations and has changed to the
safety mode.
Motor overload caused by too many
ingredients or pieces which are too
hard or too large or overuse without
Overheating of temperature sensors.
Electronic fault.
Speed fault.
Communication fault with chopper
electronic card.
Temperature sensor 2 is no longer
Please use an adequate accessory (e.g.:
For this, refer to the recommendations
in the recipes and the operating ins-
tructions provided in this manual.
Reduce the quantity of ingredients
processed.
Position the seal on the seal holder and
clip the assembly to the lid.
Change the seal, contact an approved
service centre.
recommended accessory.
Position the seal correctly.
Contact an approved service centre.
Screw the ring in place (D7).
Reduce the size or quantity of the in-
gredients processed. Add some liquid.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.
and that you are using the recom-
mended accessory.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.
Contact an approved service centre.
are not clogged. If this is the case,
clean them and try again.
approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an Approved Service Centre.
Contact an approved service centre.
Contact an approved service centre.
31
SOLUTIONS
EN
Tabla de contenido
