Machine Long Inactivity; First Period Of Use; Scheduled Maintenance Table - Nilfisk SC530 53 BD GO Guia De Inicio Rapido

SC530 QUICK START GUIDE

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the machine paragraph.
2. Disconnect the battery connector (38).

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible
parts for wear and leakage.
MAINTENANCE
WARNING!
Maintenance procedures must be performed after the machine is turned off andthe
batterycharger cable is disconnected. In addition, carefully read the safety chapters in the
manual.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel or an authorized
Service Center. This manual only describes the general and common maintenance procedures.
For other maintenance procedures that are not in below maintenance schedule table, please refer to the Service
Manual that can be consulted at any our company Service Center.

SCHEDULED MAINTENANCE TABLE

CAUTION!
The procedure marked with (1) must be performed when the machine is used after 9 hours for
the first time. The procedure marked with (2) must be done by Service Center that qualified by
our company.
Procedure
Battery charging
Squeegee cleaning
Brush/Pad-holder cleaning
Tank cleaning
Tank sealing strip inspection
Float ball filter cleaning
Squeegee blade check and replacement
Cleaning water filter cleaning
Suction filter cleaning
WET battery fluid level check
Screw and nut tightness inspection
Brush/Pad-holder carbon brush check or
replacement
Suction motor carbon brush check or
replacement
Drive system motor carbon brush check or
replacement (only for machine with traction)
Daily, after each
use
11
Weekly semiannually
（1）
ENGLISH
Yearly
（2）
（2）
（2）