Medisana MS 2200 Manual De Instrucciones página 15

3.5 Use bluetooth
The Bluetooth function of the massage chair is activated as soon as it is
powered and the on/off switch is set to position „I".
1. Activate Bluetooth on your playback device.
2. Search for the name „MCxxxxxxxxxx" in the device list and select this
device.
3. The sound of any content from your playback device is output from the
built-in speakers 2 of the massage chair.
The volume is controlled by the player.
3.6 Troubleshooting
problem possible cause
The device does not The device is not plug-
work ged in properly
The device stopped The device has just finis-
working hed its auto timer sessi-
on and has automatically
switched to standby
mode.
The device stopped You may have used the
working device continuously for
45 minutes where the
over-heat protection has
been activated.
The device stopped An excessive load has
working been applied on the
device.
The device is abnormally The device is likely to be
warm overused.
Noise can be heard from Noise is made by the
the device mechanical parts of the
device.
If the problem encountered is not listed, please try the following suggestions:
1. Turn off the product and unplug it.
2. Wait for 60 minutes.
3. Plug the product back to the recommended outlet and restart.
4. If the problem persists, contact the authorized service center.
The service centre address is shown on the attached leaflet.
If asked to do, please carry out the troubleshooting (menu „Settings" >
Start > Start) and inform our service centre of the error code.
GB
3 Operating
suggestion
Ensure the voltage on
the device corresponds
to the local mains vol-
tage and then plug in
again. Make sure the
outlet is properly wor-
king.
If you want another
session, press the power
button again.
Unplug the device and
let it cool down for 60
minutes before you use
it again.
Reduce the excessive
load and start again.
Unplug the device and
let it cool down before
using it again.
This is normal and does
not mean that the device
is faulty.
7