Declaration Of Conformity - Felisatti RHF40/1100VERT Instrucciones De Servicio

Should they need replacing, have this done by an ofi-cial
service centre. Only plug the machine in when it is switched
off.
• Always keep the lead out of the machine's working
area.
• Only plug the machine in when it is switched off.
• Do not allow the machine to get wet, nor should it be
used in wet environments.
• When using the machine, always wear safety goggles,
gloves and non-slip footwear, and it is advisable to wear
ear protection.
• Do not touch the bit during or immediately after work-
ing, as it becomes very hot and can cause serious burns.
• Hold the machine irmly by the handle and the
auxiliary handle, otherwise the recoil produced could cause
the machine to work imprecisely or even dangerously.
• Always use the auxiliary handle.
• Never attempt to clean off dust or shavings resulting
from drilling when the machine is operating.
• Do not use diamond core bits.
• When drilling walls, ceilings or loors, take care to
avoid electric wires and gas or water pipes.
Other safety information
Be sure the power supply is same as the voltage given
on the rating plate. The tool is itted with a two-core cable
and plug.
Remove the power plug from socket before carrying
out any adjustment or servicing.
Residual risks
Even when the power tool is used as prescribed
it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with
the power tool's construction and design:
- Damage to lungs if an effective dust mask is not worn.
- Damage to hearing if effective hearing protection is
not worn.
- Damages to health resulting from vibration emission if
the power tool is being used over longer period of time or
not adequately managed and properly maintained.
This
WARNING!
electromagnetic ield during operation. This ield may under
some circumstances interfere with active or passive medical
implants. To reduce the risk of serious or fatal injury, we
recommend persons with medical implants to consult their
physician and the medical implant manufacturer before
operating this machine.
4
power tool produces

DECLARATION OF CONFORMITY

Business name of the manufacturer:
12
INTERSKOL POWER TOOLS S.L.
Full address of the manufacturer:
Ctra. de St. Joan de les Abadesses, s/n
17500 RIPOLL (Girona) SPAIN
Name and address of the person
(established in the Community) compiled
the technical ile:
Jordi Carbonell, Santiago López
Stra. de St. Joan de les Abadesses, s/n
17500 RIPOLL (Girona) SPAIN
Product name: Rotary hammer
Commercial name: Rotary hammer
Model: RHF40/1100VERT,
RHF40/1100VERTM
Type: Electric power tools
Serial Number: see label of the tool
Fulils all the reevant provisions of
Directives
2004/108/EC, 2002/96/EC, 2002/95/EC,
2009/251/EC
We hereby declare, under our sole
responsibility,
brand products described in this manual
RHF40/1100VERT, RHF40/1100VERTM
comply with the following standars of
standard documents:
EN60745-1, EN60745-2-6, EN55014-1,
an
EN55014-2, EN61000-3-2, EN61000-3-3.
Jordi Carbonell
We reserve the right to make technical changes 12/2012
2006//95/EC, 2006/42/EC,
that the FELISATTI
Santiago López