Declaration Of Conformity - Felisatti RHF45/1000VET Instrucciones De Servicio

Ocultar thumbs

Contenido

página de 26

/ 26
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

placed as soon as any wear is noticed. Daily: Clean

the tool holder.

- Inspect the mounting screws: Regularly inspect all

the mounting screws and ensure they are firmly tight-

ened. Should any screw be loose, tighten it immedi-

ately. Failure to do so could put you at serious risk.

- Motor maintenance: Take the utmost care to ensure

that the motor winding is not damaged and does not

become damp with oil or water.

- Brush replacement: The brushes disconnect auto-

matically and should be replaced after 150 - 200 hours

use or when they are less than 10 mm long. Have

them replaced by an Official Service Centre.

- Clean the machine thoroughly after each use with a

blast of dry air.

- The vents of the machine should be kept clear at all

times.

- Check that the mains lead is in good condition. If it is

not, take it to an Official Service Centre to have it re-

placed.

- Use only Felisatti accessories and spares. The parts the

changing of which is not covered in this instruction man-

ual, should be replaced in a Felisatti Official Service Cen-

tre (See Warranty Official Service address leaflet).

Do not dispose of electric tools in

the household waste!

In accordance with European Directive 2002/96/EC

relating to old electrical and electronic appliances and

its translation into national law, used electric tools must

be collected separately and recycled in an ecologically

desirable way.

WARRANTY

See general warranty conditions printed on the attached

sheet.