Key Automation CT1RS Instrucciones Y Advertencias Para Su Instalación Y Uso página 16

EN
the product may not be used until the automation
system "commissioning" procedure has been
performed as specified in the "Automation sy-
stem testing and commissioning" section;
the system power supply line must include a cir-
cuit breaker device with a contact gap allowing
complete disconnection in the conditions speci-
fied by class III overvoltage;
use unions with IP55 or higher protection when
connecting hoses, pipes or cable glands;
the electrical system upstream of the automation
system must comply with the relevant regulations
and be constructed to good workmanship stan-
dards;
this appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use
of the appliance in a safe way and understand
the hazards involved;
before starting the automation system, ensure
that there is no-one in the immediate vicinity;
before proceeding with any cleaning or mainte-
nance work on the automation system, discon-
nect it from the electrical mains;
special care must be taken to avoid crushing
between the part operated by the automation sy-
stem and any fixed parts around it;
children must be supervised to ensure that they
do not play with the equipment;
drive is not to be used with doors having openings
exceeding 50mm in diameter or having edges or
protruding parts a person could grip or stand on;
that the drive cannot be used with a driven part
incorporating a wicket door unless the drive can
only be operated with the wicket door in the safe
position;
in the case of detection of an obstacle during its
closing travel, the garage door reverses its tra-
vel direction, releasing the obstacle until it opens
completely;
install the actuating member for the manual re-
lease at a height less than 1,8m. If removable,
the actuating member should be stored in direct
vicinity of the door;
install any fixed control at a height of at least
16
1,5m and within sight of the door but away from
moving parts;
after installation, ensure that the mechanism is
properly adjusted and that the drive reverses or
the object can be freed when the door contacts a
50mm high object placed on the floor (for drives
incorporating an entrapment protection system
depending on contact with the bottom edge of
the door);
after installation, ensure that parts of the door do
not extend over public footpaths or roads;
when the appliance is provided with a separate
stop button, that stop button shall be unambi-
guously identifiable.
ATTENTION !
Frequently examine the installation for imba-
lance where applicable and signs of wear or
damage to cables, springs and mounting. Do
not use if repair or adjustment is necessary.
ATTENTION !
The automation system component packa-
ging material must be disposed of in full
observance of current local waste disposal
legislation. Key Automation reserves the
right to amend these instructions if necessa-
ry; they and/or any more recent versions are
available at www.keyautomation.it.