Troubleshooting - Teac R-H500 Manual Del Usuario

Troubleshooting

Before calling for service, check through the chart below for probable causes of the problems you experience while using this unit.
Problem
Tape moves but no sound is heard.
Strange tone quality or ragged sound.
Playback sound is unclear or wavering
and clear recordings can't be made.
Probable cause(s)
The volume control of the stereo amplifier
is set to its minimum position.
The input selector of the stereo amplifier
is not set to the "tape 1" position.
The noise-reduction switch is not set to
the correct position.
The heads are dirty. There is foreign
material on the pinch rollers or capstans.
_ 9 _
Suggested remedy
Adjust the volume control to the desired
level.
Set to the "tape 1" position.
Set the switch to the position corresponding
to the setting used for recording.
Clean the heads as described in the
section "Head Maintenance".