brondell Capella Manual Del Proprietário página 11

PRODUCT INSTALLATION
Step 2: Air Gap Faucet Installation
Faucet Installation
1. Unpack the faucet, and insert the Top Spout into the Main
Body by pushing down until inserted, then screw the Top Cap
clockwise until secured in place.
2. Cut zip tie on the pre-installed 1/4-inch blue water connection
tubing, and unroll to straighten. Be careful not to cut the tube
when removing the zip tie.
3. Connect the 1/4-inch orange brine input tubing. Firmly
insert one end into the 1/4-inch brass brine input connector
underneath the faucet. Be sure that the tube is fully inserted
over the barb until it can't go further. Pull on the tube to
ensure the tube is securely in place and does not come off.
The opposite end of the orange tube will connect to the flow
restrictor later (see instructions on page 16).
4. Connect the 3/8-inch black drain tubing. Firmly insert one end
into the 3/8-inch brass drain output connector under the faucet.
Be sure that the tube is fully inserted over the barb until it
can't go further. Pull on the tube to ensure the tube is securely
in place and does not come off. The opposite end of the black
tube will connect to the drain clamp later (see instructions on
pages 11-12).
Both tubes should now be securely connected.
Step 1
Step 3
Step 4
9