Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FEATURES
1
15
6 5
4
32714
9
8
11 1210
13 16
FIG. 13
1. Cabinet
2. Vertical Air
Direction Louvers
3. Horizontal Air
Direction Louvers
4. Inlet Grille
5. Air Filter
6. Front Gdlle
7. Conb'olPanel
8. Power Cord
9. EvaporatorCoil
10. Condenser
11. Compressor
12. Base pan
13. Brace
14. Upper Guide
15. Curtain
16. Remote Control
USING THE AIR CONDITIONER
To reduce the dsk of fire, electric
shook, or injuryto persons, read the important
SAFETY instructionssection before operating this
appliance
To begin operating the air conditioner after
installation, follow these steps:
1. Plug in the air conditioner. (To prevent electrical
hazards, do not use an extension cord or an
adapter plug.)
2. Set the exhaust vent to the CLOSE position.
3. Set the TEMP Control to the coolest setting.
4. Set the MODE control at the highestCOOL level.
5. Adjust the louvers for comfortable air flow.
6. Once the room has cooled, adjust the TEMP and
Mode Control to the setting youfind most
comfortable.
NOTE : If the air conditioner is tumod off, wait 3
minutes before restarting. This allows pressure
inside the compressor to equalize. Failure to wait 3
minutes before restarting may cause inefficient
operation.
If you move the TEMP Control to a warmer, then
immediately back to a cooler setting,the unit will
shut off. Wait 3 minutes before restarting.
VENT CONTROL
The Vent Control allows the air conditionerto
either recimulate inside air (CLOSE) or exhaust
air to the outside (OPEN). (FIG. 14)
• The CLOSE position is used when maximum
cooling is desired. It may also be used for air
recirculationwithoutcooling when the air
conditioner is set in the FAN position.
• The OPEN position removes stale air from the
room and exhausts it to the outside. Fresh air is
drawn into the room through your home's
normal air passages.
• The OPEN or CLOSE position can be used with
any mode selection.
PULL OPEN I PUSH CLOSE
FIG.
14
-9-
Capítulos
Tabla de contenido
