Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
For easy installation, select an existing light operated by
a wall switch for replacement.
For best performance, mount the fixture about
8 feet (2.4 m) above the ground.
❒ Drill the holes needed to
mount the backplate to
the junction box.
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
Eave Mount
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
For eave mount only:
❒ Rotate the sensor head towards the clamp screw
joint.
Joint Clamp
❒ Then rotate the sensor head clockwise 180° so the
controls face down.
❒ Turn power off at the fuse or circuit breaker.
❒ Remove the existing light fixture.
❒ Route the Light Control's wires through the large
❒ Connect the junction box wires to the Light Control
Wall Mount
❒ Align the Light Control cover plate and the junction
❒ If not installed on a weatherproof box or if an
Control Switch
Lock nuts
❒ Adjust the lamp holders by loosening the lock nuts
2
W
L
IRE THE
IGHT
gasket hole.
wires. Twist together and secure with a wire
connector.
Black to
Black
White to
White
M
L
OUNT THE
box holes. Secure with the mounting screws.
adaptor plate (not included) was used, caulk the
wall plate and mounting surface with silicone.
but do not rotate the lamp holders more than 180°
from the factory setting. When screwing in the
floodlamps, do not overtighten.
C
.
ONTROL
Gasket
C
.
IGHT
ONTROL
Avoid water damage and
electrical shock - keep lamp
holders below horizontal.
Keep lamps at
least 1" (25 mm)
from the sensor.
595-5292-18
Tabla de contenido
