Heath Zenith Secure Home SH-5407 Manual Del Usuario

Replacement
Motion Sensor
Model SH-5407
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight
hours.
• LED indicates motion was sensed (day or
night).
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must
be wired through a switch.
• Some codes require installation by a qualifi ed
electrician.
OPERATION
Mode: On-Time:
Test 5 Sec
Normal 1, 5, 10 min.
Manual Until Dawn*
* resets to Auto Mode at dawn.
Note: When fi rst turned on wait about 1
for the circuitry to calibrate.
© 2007 HeathCo LLC
Works: Day Night
x x
x
x
1
/ minutes
2
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.
Put the ON-TIME switch in the 1,
5, or 10 minute position.
MANUAL MODE
Manual mode only works at night
because daylight returns the sen-
sor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1, 5,
or 10 position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
1
calibration time (1 /
2
AUTO mode.
TEST
ON-TIME
10 5 1 TEST
AUTO
ON-TIME
10 5 1 TEST
1 Second OFF
then...
... back on.
Move ON-TIME Switch
to 1, 5, or 10 minutes
Flip switch off for
one second then
back on*
min.) the control will be in the
598-1155-01