Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7
Securely insert the front line into the appliance
(snaps into place). For this purpose, put the
appliance to be plugged in just on to the edge of
the unit. Plug the power cord into the socket.
Plug transformer into dedicated receptacle in an
accessible cabinet adjacent to the coffee maker
(depends on the built-in situation). Do not plug into
a receptacle behind the appliance.
Note: The appliance can be directly connected to
the home network. To do this, connect the
appliance using a LAN cable (not included).
Important:
‒ The distance between the appliance and the rear
wall must be at least 1
‒ The power cord or the LAN cable should not be
kinked or crushed.
8
Push the appliance into the unit until it clicks into
place. Check that the appliance is in the middle. If
necessary, align the appliance. To do so, pull the
appliance out a little, remove the appropriate
spacers
and attach to the left side (top and
(d)
bottom). Push the appliance into the unit until it
clicks into place.
9
Take hold of the appliance door on the right next to
the outlet and open. Remove the drip tray
the cover
(X)
on the bottom left-hand side forwards
and remove. Pull out the accessories drawer
and put to one side.
10 First, secure the appliance using 2 fastening
screws
(e)
each and
Lastly, screw in the fastening screw
on the cabinet's top right.
(h)
Then:
‒ Open the door at approx. 55°.
‒ Screw the screws in
‒ Re-fit the hinge dampers
11
Only for the expert:
In very few cases, the door of the fitted fully
automatic coffee machine can jam due to a warpage
in the cabinet where the unit is built in. The door
can be adjusted. To do this adjust the hinges at the
top and the bottom:
‒ Adjust the depth of the door by turning the
screws
.
(V)
‒ Remove the hinge dampers at the top and
bottom of the hinges. Turn the screws
adjust the inclination and the horizontal position
of the doors.
‒ Re-fit the hinge dampers.
12 Insert the cover
(X)
fastening screws
(g)
13 Replace the drip tray
and close the appliance door.
(Z)
3
⁄
" (35 mm).
8
(Y)
(f)
the 2 sleeves
(i)
as shown.
and sleeve
(e)
.
(l)
.
(m)
(W)
and fix with the two black
.
(Y)
and accessories drawer
Removal
1
Undo all screws.
2
Slightly pull out the appliance.
3
Remove the power cord from the socket.
4
Disconnect the appliance from the transformer.
5
Fully remove the appliance.
Technical specifications
Power connection with
transformer type 8001010566
(voltage - frequency)
Power rating
Maximum static pump pressure
Maximum water tank capacity
(without filter)
Maximum capacity of the coffee
. Pull
bean container
Length of power cable
(Z)
(Power socket - transformer)
Dimensions
(appliance without transformer)
H x W x D
Weight, empty
(appliance without transformer)
Type of grinding unit
to
120 V AC - 60 Hz
1600 W
19 bar
81.15 oz (2.4 l)
17.64 oz (500 g)
39" (1 m)
17.91 x 23.23 x 17.48"
(455 x 590 x 444 mm)
46 - 49 lb (21 - 22 kg)
Ceramic
11
Tabla de contenido
