HAMPTON BAY LUXENBERG 91136 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (FF) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (FF) and
lockwashers (GG) in the round holes. This will enable you to
remove the mounting bracket (A).
FF
GG
FF
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the two setscrews (HH) on the
collar (II) on top of the motor housing.
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar (II) on top of the motor housing.
□
Carefully insert the hanger pin (DD) through the holes in the
collar (II) and downrod (B). Be careful not to jam the hanger
pin (DD) against the wiring inside the downrod (B).
□
Insert the locking pin (EE) through the hole near the end of
the hanger pin (DD) until it snaps into its locked position.
□
Re-tighten the two setscrews (HH) on the collar (II) on top of
the motor housing.
2
Routing the wires
□
Make sure the slot openings are on top, route the wires
from the fan-motor assembly (D) through the canopy
(C), and then through the ball/downrod assembly (B).
C
A
B
C
D
EE
HH
7
Please contact 1-855-HD-HAMPTON for further assistance.
B
DD
II
HAMPTONBAY.COM