Installation Instructions - Sears Kenmore 106.7200 Manual De Uso Y Cuidado

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
Excessive
Weight
Hazard
Use two or more people
to move and install
refrigerator.
Failure
to do so can result
in back or other
injury.
Remove the Packaging
Remove tape
and glue residue from surfaces
before
turning
on
the refrigerator.
Rub a small amount
of liquid
dish soap over
the adhesive
with your fingers.
Wipe
with warm
water
and dry.
Do not use sharp instruments, rubbing
alcohol,
flammable
fluids, or abrasive
cleaners
to remove
tape
or glue. These
products
can damage
the surface of your refrigerator.
For more
information,
see "Refrigerator
Safety."
Dispose of/recycle
all packaging
materials.
When Moving Your Refrigerator:
Your refrigerator
is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the refrigerator straight out when moving it. Do not wiggle or
"walk" the refrigerator when trying to move it, as floor
damage could occur.
Clean Before Using
After you remove
all of the packaging
materials,
clean the inside of
your refrigerator
before
using it. See the cleaning
instructions
in
"Refrigerator
Care."
important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature
changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size
pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
Explosion
Hazard
Keep
flammable
materials
and vapors,
such
as
gasoline,
away
from
refrigerator.
Failure
to do so can
result
in death,
explosion,
or fire.
To ensure proper
ventilation
for your refrigerator,
allow
for a 1/2"
(1.25 cm) of space on each side and at the top. Allow for a 1"
(2.54 cm) space behind
the refrigerator.
If your refrigerator
has an
ice maker, allow
extra
space at the back for the water
line
connections.
When
installing
your refrigerator
next to a fixed
wall,
leave a 33A'' (9.5 cm) minimum
space between
the refrigerator
and
wall to allow
the door to swing open.
NOTE:
It is recommended
that you do not install the refrigerator
near an oven, radiator,
or other heat source. Do not install the
refrigerator
in a location
where the temperature
will fall below
55°F (13°C).
/
1/2"(1.25 cm) /
IL
J
33/4"(9.5 cm)
/
\
Tabla de contenido
loading

Este manual también es adecuado para:

Kenmore 106.7201

Tabla de contenido