Tabla de contenido
Idiomas disponibles
Idiomas disponibles
If You Choose to Turn Off the Refrigerator
Before
You Leave:
1.
Remove all food
from the refrigerator.
2.
If your refrigerator
has an automatic
ice maker:
•
Turn off the water
supply to the ice maker at least one day
ahead
of time.
•
When
the last load of ice drops,
raise the wire shutoff
arm
to the OFF (up) position
or press the switch to OFF,
depending
on your
model.
3.
Turn off the Temperature
control(s).
See "Using
the Control(s)."
4.
Clean
refrigerator,
wipe
it, and dry well.
5.
Tape rubber
or wood
blocks to the tops of both doors to prop
them open far enough
for air to get in. This stops odor and
mold from
building
up.
Moving
When
you are moving
your refrigerator
to a new home, follow
these steps to prepare
it for the move.
1.
If your refrigerator
has an automatic
ice maker:
•
Turn off the water
supply to the ice maker at least one day
ahead
of time.
•
Disconnect
the water
line from the back of the refrigerator.
•
When
the last load of ice drops,
raise the wire shutoff
arm
to the OFF (up) position
or press the switch to OFF,
depending
on your model.
2.
Remove all food
from the refrigerator
and pack all frozen
food
in dry ice.
3.
Empty the ice bin.
4.
Turn off the Temperature
control(s).
See "Using
the Control(s)."
5.
Unplug
refrigerator.
6.
Clean, wipe,
and dry thoroughly.
7.
Take out all removable
parts, wrap
them well, and tape
them
together
so they don't
shift and rattle
during
the move.
8.
Depending
on the model, raise the front of the refrigerator
so it
rolls more easily OR raise the leveling
screws so they don't
scrape
the floor.
See "Adjust
the Door(s)."
9.
Tape the doors closed and tape the power cord to the back of
the refrigerator.
When
you get to your new home, put everything
back and refer to
the "Installation
Instructions"
section for preparation
instructions.
Also, if your refrigerator
has an automatic
ice maker,
remember
to
reconnect
the water
supply
to the refrigerator.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
•
New installation? Allow 24 hours following installation for the
The refrigerator will not operate
Electrical
Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death_
fire_ or electrical shock.
•
Power cord unplugged?
Plug into a grounded
3 prong outlet.
•
Is outlet working?
Plug in a lamp to see if the outlet
is working.
•
Household
fuse blown
or circuit
breaker
tripped?
Replace the
fuse or reset the circuit
breaker.
If the problem
continues,
call
an electrician.
refrigerator
to cool completely.
NOTE: Adjusting
the temperature
controls
to coldest
setting will
not cool either
compartment
more quickly.
The motor seemsto runtoo much
Your new refrigerator
may run longer
than your old one due to its
high-efficiency
compressor
and fans. The unit may run even longer
if the room is warm,
a large food
load is added,
doors are opened
often,
or if the doors
have been left open.
The refrigerator seems noisy
Refrigerator
noise has been reduced
over the years. Due to this
reduction,
you may hear intermittent
noises from your new
refrigerator
that you did not notice from your old model.
Below are
listed some normal
sounds with explanations.
•
Buzzing
- heard when the water valve
opens to fill the ice
maker
•
Pulsating
- fans/compressor
adjusting
to optimize
performance
•
Hissing/Rattling
- flow
of refrigerant,
movement
of water
lines,
or from items placed
on top of the refrigerator
•
Sizzling/Gurgling
- water dripping
on the heater during defrost
cycle
•
Are controls
on? Make
sure the refrigerator
controls
are on. See
"Using
the Control(s)."
2O
Tabla de contenido
