Setting The Set-Point - Ariston LYDOS WIFI 80 V Manual De Instrucciones

EN
Two different setpoint temperatures at two different times can be selected for each day of the week: the
product will calculate the heating speed and, depending on the temperature, the best moment to start
heating in order to reach the setpoint at the desired time.
Press the MODE button to deactivate the function.

Setting the set-point

Press the MODE button to select the setpoint temperature (indicated by the temperature LEDs with the other LEDs off).
Every time the buttons are pressed, the temperature will increase or decrease by 20 degrees. After 5 seconds without
any operation, the setpoint will be confirmed and saved.
STALL STATUS
There are two possible stall statuses:
- TOUCH CONTROL STALL STATUS
If a touch control error is detected, the status of the touch LED is undetermined and cannot be controlled.
This status is indicated by the flashing of the temperature LEDs (fast if the product is on, slow if it is off).
- OTHER STALL STATUS
If other errors are detected, all the LEDs will start flashing.
To reset a non-volatile error, if possible, it is necessary to press the ON/OFF button (Fig. 3A) to switch the product
on and off. To verify which error occurred, it is necessary to enter the diagnostics state by simultaneously pressing
the ON_OFF and MODE for 3 seconds. In this state, the temperature LED must show the defect according to Table
1.4. After 25 seconds, the system will return to the stall status. Note: for the Chinese market (set through NFC), the
product is reset by simultaneously pressing the ON/OFF and ECO buttons for 5 seconds.
WI FI
To check which error has occurred, enter into the diagnostics state by pressing the ON_OFF and MODE buttons
.seconds 3 simultaneously for
WI FI
The WiFi module is switched on / off by pressing the corresponding button: if the WiFi is connected and functioning
.correctly, the corresponding LED is steady on, if the WiFi is in error (error comm), the WiFi LED is off
In idle state (WiFi switched on but not configured), the Wifi LED will flash normally, so the WiFi button must be pressed
seconds if the 25 minutes (or 10 seconds to enter into AP mode: the module remains in AP mode for a maximum 5 for
AP mode has not been entered correctly, in which case it returns to the previous state). This state is indicated by the
.WiFi LED flashing rapidly
.(In the provisioning phase, the LED will flash rapidly twice and switch off once (and so on
.seconds to restore the Wi-Fi configuration 10 Press the [MODE] and [WIFI] buttons simultaneously for
the AP command and the Soft Reset command must only be used if the WiFi is enabled and an error comm is :1 NOTE
.not detected
.seconds 25 after the AP command, the WiFi button must be deactivated for :2 NOTE
18