3M PX5 Manual De Usuario página 14

Finishing
1
Switch off the power of the connected equipment
2
Switch off the power of the projector
Press the STANDBY button on the remote control or
the projector.
STATUS STANDBY
The [Power Off] display appears.
When the level gauge reaches maximum, the projec-
tion screen will go off (in about 5 seconds) and the
projector will enter the power-off operation.
Note:
• The operation can be cancelled by pressing a but-
ton other than the STANDBY button.
• One more press of the STANDBY button will switch
off the power.
The STANDBY indicator changes to flashing amber
and lights a steady amber after about 90 seconds
(when the unit enters the standby mode).
3
Unplug the power cable
Check that the STANDBY indicator is lit in amber and then unplug the power cable.
The STANDBY indicator will go off when the power cable is unplugged.
4
Turn the lens cover counterclockwise until it stops.
1
The lens cover will stop with a click.
Unplug & Go function
When the power cord is unplugged directly after the power is turned off, the internal power supply is
used to keep the cooling fan turning and cool the lamp, so the projector can be moved immediately.
• It may be more difficult to turn the lamp back on if it has been cooled with the power cord unplugged.
• Do not place the projector in a bag, etc., while the cooling fan is turning.
(button on main unit)
2
STATUS STANDBY
Lit green
E-14
Power Off
OK ?
STATUS STANDBY STATUS STANDBY
Flashing amber Lit amber
(Approximately Standby
90 seconds) mode