Buttonhole - ALFA 2622 Manual De Instrucciones

1
BH
1 2 3
4
5
1
6 7 8
2
3
5
4
6
2

Buttonhole

Pattern selector:
1
Presser foot:
2
3 Thread tension:
Stitch length:
4
5 Stitch width:
* The size of buttonhole is automatically set by placing
the button in the automatic buttonhole foot.
* The button holder of the foot takes a button size up to
2.5 cm (1") in diameter.
* Make a test buttonhole on a sample duplicating the
fabric, interfacing and seams of the actual garment.
* Place the button on the fabric sample and mark the
top and bottom to determine the position of buttonhole.
* Use interfacing on stretch fabrics.
1 Turn the handwheel toward you to raise the needle to
its highest position.
Raise the presser foot lifter.
2 Select the pattern "BH" by turning the pattern selector
dial.
If the BH pattern is already selected, reset the dial once
according to the procedure in 12 .
3 Attach the automatic buttonhole foot.
4 Pull the button holder to the back, and place the button
in it. Push back the button holder toward you as far as
it will go.
5 Pull the buttonhole lever downward as far as it will go.
1
Buttonhole lever
6 Insert fabric under the foot.
Turn the handwheel slowly towards you with your right
hand until the needle goes down and continue turning
handwheel until the take-up lever is at its highest position.
7 Remove the fabric to the left to draw both threads to
the left.
8 Insert the garment under the foot, and lower the needle
at the starting point.
3 Then lower the automatic buttonhole foot.
4
Note :
Make sure there is no gap between the slider and the
spring holder. If there is a gap, the length of the rows
5
will be different, as shown.
Starting point
2
3 Slider
4 There should be no gap
5 Spring holder
6 Difference
20
(BH)
Automatic buttonhole foot
1–5
(0.5 –1)
5