After Use; Maintenance Schedule - Advance SC1500 Instrucciones De Uso

Tabla de contenido

Idiomas disponibles

A - ENGLISH

AFTER USE

When ﬁ nished scrubbing, press the One-Touch Scrub Switch (I), this will automatically raise, retract and stop all the machine systems (brush, squeegee,

vacuum, solution and detergent. Then drive the machine to a service area for daily maintenance and review of other needed service upkeep.

To empty the solution tank:

Direct the Solution Tank Drain Hose (22) toward a designated "DISPOSAL SITE" and open the Solution Drain Valve (34). Also the tank can be drained by

closing the Solution Shutoff Valve (27) and removing the cap from the Solution Filter (26), then open the Solution Shutoff Valve to drain the solution out

through the ﬁ lter. Rinse the tank with clean water.

To empty the recovery tank, pull the Recovery Tank Drain Hose (30) from its storage area. Direct the hose to a designated "DISPOSAL SITE" and unscrew

the cap (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled ﬂ ow of waste water). Unlatch (29) and lift open the

Recovery Tank Cover (13) set the prop rod (32). Inspect and empty the Debris Catch Tray (16) in the recovery tank. Rinse the tank with clean water.

Remove the brush or pad holder. Rinse the brush or pad in warm water and hang up to dry.

Remove the squeegee, rinse it with warm water and hang it up to dry.

Check the maintenance schedule below and perform any required maintenance before storage.

Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.

Turn the Key Switch (A) OFF (O) and remove the key.

Batteries are the most expensive replacement item on this machine. To protect your investment and to get as many cycles from the batteries as possible,

remember the following:

• Batteries will last longer if kept fully charged.

• Batteries equipped with this machine will not develop a memory.

• Batteries will last longer and will deliver more cycles if they are opportunity charged.

• Battery chargers will not over or undercharge the batteries.

• Batteries will prematurely fail if stored in a discharged state.

• When the machine is not being used, plug the machine in to charge the batteries.

• Every day after use, the battery charger must be plugged in and the charger must be allowed to run through a full charging sequence to fully charge the

batteries.