After Use; Maintenance Schedule; Important; Lubricating The Machine - Advance VacRide 3400 Instrucciones De Uso

Tabla de contenido

Idiomas disponibles

A-14 / ENGLISH

AFTER USE

When ﬁ nished vacuuming, manually raise the vacuum deck to turn off all systems. Then drive the machine to a service area for daily maintenance and

review of other needed service up keep.

Remove the brushes then rinse them with warm water and remove any built up string, hair or carpet ﬁ bers. Hang the brushes up to dry.

Check the maintenance schedule below and perform any required maintenance before storage.

MAINTENANCE SCHEDULE

Keep the machine in top condition by following the maintenance schedule closely. Maintenance intervals given are for average operating conditions.

Machines used in severe environments may require service more often.

Check/Clean the vacuum motor foam ﬁ lter(s)

* Have Advance check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes check every

500 hours or once a year.

NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.

Store the machine indoors in a clean dry place. Keep from freezing.

Turn the Master Key Switch (A) OFF (O) and remove the key.

SERVICING THE VACUUM MOTORS

Have your Nilﬁ sk-Advance Dealer check the carbon motors brushes once a year or after 300 operating hours.

IMPORTANT!

Motor damage resulting from failure to service the carbon brushes is not covered under warranty. See the Limited Warranty Statement.

LUBRICATING THE MACHINE

Once a month, pump a small amount of grease into each grease ﬁ tting on the machine until grease seeps out around the bearings. Wipe off any excess grease to

avoid staining carpet.

Grease ﬁ tting locations (or apply grease to) (AA):

•

Vacuum Deck Caster Wheels

Once a month lubricate the pivot points below. For

best results, use a spray silicone lubricant.

•

Steering Chain

•

General Pivot Points for the Side Broom and

Vacuum Deck Linkage.

•