Operation; Fastening The Laser Unit To The Wheel; Switching The Laser Unit On/Off; Maintenance - Bosch SCT 416 L1 Manual Original

en 14 | SCT 416 L1; ACC 100/200 | Operation
5.

Operation

5.1

Fastening the laser unit to the wheel

The laser units must be fastened to the rear wheels of
the motor vehicle in the following manner:
1. Attach a multiquick clamp to each rear wheel
(optional accessory).
2. Fasten the socket pin of the laser unit in the central
opening of the multiquick clamp.
3. Close the tensioning lever to secure the socket pin.
Fig. 5: Fastening the laser unit
1 Socket pin
2 Central opening with tensioning lever
5.2

Switching the laser unit on/off

Switch the laser unit on and off at the back.
Fig. 6: Back of laser unit
1 Battery compartment cover
2 On/Off switch
|
1 690 386 045 2018-10-26
6.

Maintenance

6.1

Cleaning

R
Clean only with a soft, lint-free cloth.
R
Do not use abrasive cleaning agents and coarse
workshop cloths!
R
Never use solvent-based cleaning agents. These
could attack the safety labels on the product in
particular.
6.2

Maintenance tasks and service

Replacing the battery
i
Each laser unit needs 2 batteries. Type: 1.5 V, LR14,
C.
Fig. 7: Back of laser unit
1 On/Off switch
2 Battery, positive terminal at the top
3 Battery compartment cover
!
Make sure that the laser unit is off (switch in the "O"
position).
1. Turn the cover of the battery compartment and
remove it.
2. Remove the old batteries.
3. Insert two new batteries.
i
The positive terminal of each battery must be at the
top (facing the cover).
4. Close the battery compartment of the laser unit.
Robert Bosch GmbH