Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6
Fine tune the outline shape of the boundary wire if necessary.
If the verification test is completed smoothly, you can start mowing by pressing
If there is any problem during verification test, please refer to "Owner's manual-Troubleshooting".
Setting
First please set the height to a desired grass level after cut and you can do the program setting manually or using
mobile App.
NOTE: When doing the program setting manually, Mission
receive any input from the user within 30 seconds.
1
Change PIN code
To change the PIN code, keep pressing both
buttons at the same time for 5 seconds. The icon
will be blinking, and "
After that, the first number will be blinking, use
to input the old PIN code and press
next number will be blinking. Use the same method to
complete other numbers. Then,"
flashing , the first number will be blinking and use
to
select the number you want and press
confirm. The next number will be blinking. Use the same
method to complete other numbers. For example, the
new PIN code is set to be 0326. After that, "
be rolling flashing and the first number will be blinking
again. Use the same method to input the new PIN
code you set just now (in this example,
" will be rolling flashing on the display. Your
PIN code has been changed successfully.
2
Set year, date and time
Set year, date and time are compulsory setting
items. If you don't set these items, it will influence the
schedule time in the following setting. These items
should be set in the order of year, date and time. For
the year setting, keep pressing
the icon
and a number are blinking on the display,
for example,
. Use
you want. Then press
setting.
Meanwhile, the icon
a number will be displayed to indicate the date, for
example,
, meaning September 29. When
flashing, use
or
to select the number and press
to confirm. Then
method to select the number and press
finish the date setting.
and
" will be rolling flashing.
to confirm. The
" will be rolling
). Then "
for 3 seconds until
or
to select the year
to confirm to finish the year
will be flashing again and
will be flashing. Use the same
to confirm to
NANO will enter the standby page if it does not
TM
or
or
to
" will
is
then
.
Only for reference
Only for reference
Only for reference
9
En
Tabla de contenido
