Kress Robotik MISSION NANO Guia De Inicio Rapido página 7

After pegging the boundry wire, please take your
Mission NANO away from the charging base. Lead
TM
the boundary wire back to the charging base, leave
a length of the boundary wire (OUT-wire) around
80cm and cut it off. Insert both wire ends into the
grooves on the charging base.
Peel off the plastic skin at the end of both wires
(around 1cm), and connect the naked metal wire
end of the IN-wire to the BLACK terminal and the
end of OUT-wire to the RED terminal.
OUT
If your lawn has multiple areas connected to each other by a corridor, it should be at least 1 meter wide. If
the corridor is narrower than 1 meter, Mission
recommended to set up a main area and a secondary area in your lawn. The boundary wire should be placed
as illustrated in the picture. When the secondary area has to be cut, please pick up Mission
bring it to the secondary area. Mission
charging base when the battery runs out.
OUT WIRE
IN
NANO will have difficulty travelling between. In this case, it is
TM
NANO will mow without problem, but you have to bring it back to the
TM
90
o
Main area
IN WIRE
90
o
NANO and
TM
Secondary area
<1m
7
En