Kress Robotik MISSION NANO Guia De Inicio Rapido página 6

Installation
1
Place the charging base
Find a flat surface for the charging base, the place
should be dry and out of direct sun light and the
adapter can be mounted on the wall.
2
Charge Mission NANO before first operation
TM
Connect the adapter to the electrical outlet. The
LED on the charging base will turn on in green color.
Manually dock Mission NANO into the charging
TM
base while Mission NANO is powered off. The
TM
green light on the charging base will be flashing and
Mission NANO will begin to charge.
TM
6
En
3
Peg the boundary wire
Pull out a length of boundary wire around 80cm
and fasten it to the ground near the charging base.
Later, this end of the boundary wire (IN-wire) will
be connected to the BLACK terminal after pegging
your boundry wire.
NOTE: The extended boundary wire should not exceed
350m or it may cause signal problem.
4
Complete the entire boundary wire setup
Lay down the boundary wire around the working
area as the illustration shown.