Uline H-7098 Manual De Instrucciones página 2

INSTALLING FAN
1. The fan must be mounted so the oscillating
mechanism (oscillator base, linkage arm, etc.)
is facing down.
2. Set the "sweep" for 90° or 45° by securing the
linkage arm to the eccentric hub using the
appropriate threaded hole. The fan is shipped
factory-assembled for 90°. To change the sweep to
45°, remove the bolt from the outside threaded hole
and reattach using the inside threaded hole.
(See Figure 1)
NOTE: The connecting bolt and threaded holes
have left-hand threads.
Figure 1
Eccentric Hub
Inside Hole
Linkage Arm
Outside Hole
3. Ensure nothing is restricting or obstructing the full
range of oscillation.
4. Oscillator Drive Knob: Pull the knob up to disengage
the drive. Push the knob down to engage the drive.
5. Pull the chain switch to start the fan motor. The
sequence for the 2-speed chain switch is as follows:
a. Off
b. On (low speed)
c. Off
d. On (high speed)
PAGE 2 OF 12
Chain Switch
INSTRUCTIONS
INSTALLING FAN ON WALL MOUNT BRACKET
NOTE: Wall mount bracket must be oriented
with mounting leg and diagonal brace down.
(See Figure 2)
1.
Use the supplied hardware to attach the fan.
2. Fasten the oscillator motor mounting yoke to the wall
mount bracket using the 3/8" carriage bolt, 3/8" wide
washer and nyloc nut. (See Figure 2)
Figure 2
3. Install the 3/8" bolt through the center hole of the
oscillator base and fasten with 3/8" narrow washers
and nyloc nut. (See Figure 3)
4. Install the 1/4" bolt through the slot feature and
fasten with the 1/4" narrow washers and nyloc nut.
Adjust the fan to the desired angle and securely
tighten all mounting hardware. (See Figure 3)
Figure 3
1/4" Bolt
NOTE: Figure 3 shows motor without fan head.
Product will come with motor installed to fan
head.
NOTE: 36" models must be mounted so the fan
blade is perpendicular to the floor.
CAUTION! Nuts may loosen over time. It is
important to check and tighten fasteners
frequently.
CAUTION! Inspect mounts and fasteners
frequently for corrosion. Replace any corroded
fasteners or parts.
3/8" Bolt
3/8" Carriage Bolt
3/8" Washer
Nyloc Nut
3/8" Narrow
Washer
Nyloc Nut
1/4" Narrow Washer
0821 IH-7098