Heath Zenith 4350 Manual De Instrucciones página 6

5. Adjust the SENSITIVITY to increase or de-
crease the range as needed. Too much sen-
sitivity may cause false triggering due to heat
sources in the coverage area (see Adjustment of
Coverage Area or Troubleshooting section).
IT Y
IT IV
–
N S
S E
+
6. Set the amount of ON-TIME you want the light
to stay on after motion is detected (1, 5, or 10
minutes).
7. Set the amount of time you want the light to
stay on in the Accent mode (Off, 3 hours, 6
hours, or dusk-to-dawn).
Note: Meets the ENERGY STAR
D B function is off.
®
ual rite
8 ft. (2.4 m)
30 Feet (9.1 m)
in all Directions
Maximum Range
* Without lens shield installed.
The sensor is less sensitive to motion directly
towards it and more sensitive to motion across
coverage area.
Motion
Least Sensitive
SENSITIVITY
+
guidelines when
®
Coverage Angle*
(Top View)
Motion
Sensor
Most Sensitive
adJustMent OF cOverage
The sensor on this light fixture detects "motion"
by the movement of heat (body heat) across the
coverage area. However, following are examples
of objects that also produce heat and can cause
the sensor to false trigger:
–
• Pools of Water
• Dryer Vents
• Heating Vents
If you suspect that a heat source of this type is falsely
triggering the sensor and reducing the sensitivity
does not solve the problem, then a lens shield
(included) can be installed. The plastic lens shield
is divided into 6 sections. Each section will reduce the
coverage angle by 30 degrees. Also, the tip of each
section may be removed to change the effective
range of the sensor.
1. Break off the amount of lens shield needed to
block the desired area of coverage.
360°
Lens
Shield
Effective Coverage
Area (Top View)
Lens
Shield
Portion
Removed
6
area
• Air Conditioners
• Fenced-In Animals
• Automobile Traffic
Area
Blocked
Area
Blocked
598-1219-05