Temperature Sensor - Blaupunkt 5C90S8990 Instrucciones De Uso

3. After steam cooking:
1- When the steam cooking process is finished, the water in the boiler is returned to the water
tank. This process takes about 1 minute.
2- If the water tank becomes too full, the system will beep 10 times. In this case, empty the
water tank. When the water tank is empty, the system will continue the process.
NOTE: Empty the water tank after steam cooking.
ERROR CODES
During steam cooking, the following error codes may be displayed:
E-06: 1- The water tank is not properly closed.
E-05: The water system is not working properly. Contact customer service.
Possible causes:
1- The water sensor is not working.
2- The water pipe is not working.
3- The water pump is not working.
4- The water tank is not working.
17. Automatic deposit removal function
For best cleaning results, we recommend the use of sodium citrate. Follow the manufacturer's
instructions on the packaging. If the steam function has been running for 20 hours, the descaling
function should be switched on afterwards.
1) Switch on the system. Remove the water tank and add 1000 ml of fresh water and a pack of
descaling agent.
2) Push the water tank back in.
3) In standby mode, tap the
that the appliance has switched on the automatic descaling function. The 40:00 min display will
light up. The symbol for the water tank will show the current water level and other symbols will
disappear.
4) Press to start the program.
5) If 10 min remain, the program will stop and water must be refilled. Remove the water tank and
pour the water in. Clean the water tank thoroughly.
6) Add fresh water and repeat steps 3 to 4.
NOTE: Do not interrupt the descaling process. If the descaling process is interrupted before the
end, the entire program must be restarted starting from step 3.

18. Temperature sensor

1) You can use the temperature sensor in any operating mode. When you use it, a signal will
sound. The display will show "Prob".
2) In "Temperature sensor" mode, tap
the temperature sensor will appear on the display.
button several times until the display shows "CLE". This means
to select the heating mode. The default temperature of
18