Error Messages And Error Clearance; Original Declaration Of Conformity - Weller Laser Line 200 Traducción Del Manual Original

Error messages and error clearance

Message/symptom
Extraction power missing

Loud extraction noises

Unit is not running

Filter display is not working

Sub-micron paricle becoming

dirty to quickly
Unable to detect USB medium

Reset unit


Original declaration of conformity

Extraction unit
We hereby declare that the products described herein comply with the following guidelines:
2011/65/EU (RoHS), 2014/30/EU, 2006/42/EG
Applied harmonised standards:
EN 55 014-1: 2012-05
EN 55 014-2: 2009-06
EN 61 000-3-2: 2010-03/2011-06
EN 61 000-3-3: 2014-03
Besigheim, 2016-02-17
T. Fischer
Technical director
Authorised to compile technical documentation.
Weller Tools GmbH
Carl-Benz-Straße 2, 74354 Besigheim, Germany
22
Possible cause
Pipe system leaking

Filter is dirty

Turbine speed too low

Air speed through extraction-

arm is too high speed
Thermally switched off

Minimum pressure hose was

not replaced after the filter
change
Pre-filter has not been used

USB medium inserted too long

Wrong USB medium > 100

mA
Laser Line 200V
Laser Line 400V
EN 60 335-1: 2012-10
EN 60 335-2-45: 2012-08
EN 62233: 2008-11/2009-04
EN 50 581: 2013-02
B.Frühwald
Managing director
Remedial measures
Reseal the pipe system

change the filter

Increase the speed setting

Reduce the air speed (reduce

air quanitity)
Leave the unit to cool down.

Switch on again after approx.
3 hours.
Reconnect the hose to the

filter
Use prefilter

Do not leave USB medium

inserted for longer than 2
minutes. Remove USB
medium and switch unit off
and on again
Remove USB medium!
