Tabla de contenido
This Quick Start Guide does not replace the Operating
Instructions of this product. For complete instructions and
safety handling information, see the Operating Instructions
on the:
Touchscreen Unit
DVD
Delivered with the product
Proceq Website
www.proceq.com Downloads
Scope of Delivery
Upgrade Kit to Pundit 250 Array (327 30 130)
Pundit 250 Array (327 30 110)
Pundit PL-200PE (327 20 001)
Pundit PL-200 (327 10 001)
Pundit Touchscreen (327 10 002)
A Carrying Case
B Pundit Touchscreen
C Battery
D Power Supply
E USB Cable
F 2 Transducers 54 kHz
G 2 BNC Cables 1.5 m
H BNC Adapter Cable
I
Couplant
J Calibration Rod
K Pundit Pulse Echo Transducer
L Pundit Pulse Echo Cable
M Pundit Pulse Echo Contact Tester
N Calibrated Tape
O Pundit Array Transducer
P Pundit Array Cable 1.5 m
Q 6x Rechargeable AA
R Pundit Array Contact Tester
S Activation key
T Carrying Strap
U DVD with Software
V Documentation
© 2016 Proceq SA
Getting Started
1
Battery Installation Pundit
Touchscreen
Remove the protection foil and
lift the stand as shown. Insert the
battery and fasten in place with the
screw.
The battery must be charged for 8 hours before first use.
Connect through the power supply connection. A Quick
charger is also available (full charging < 5.5 h).
Battery Installation Pundit Array Transducer
Remove the battery pack by loosening the two screws.
WARNING!
!
Insert the six AA recharge-
able batteries being sure to
observe the correct polarity.
Before first use, fully charge the batteries using the charger
provided. Press the fuel gauge button to check the charge
status. 5 LEDs lit indicate a charge of more than 80%.
Connect the Transducer
• • • • •
• • • •
• • • •
• • • •
• • • •
Connect the array transducer
•
to the 12 pin connector using
the cable provided.
•
• •
•
Start the Pundit Touchscreen
•
Power On/Off – Press to power on. Press and hold to
•
power off.
•
•
Soft Key – Switches in and out of full screen view.
• • •
• •
Back Button – returns to previous screen.
• •
It is recommended to check for firmware upgrades
• •
before
using
the
• •
(See PL-Link).
•
Start the Pundit Array Transducer
• • • •
• • • • •
Press the Power button to turn the transducer on. It
takes about 20 seconds to boot up.
• • • • •
Connect the pulse echo
and the standard pulse
velocity transducers to the
sub-D connector using the
cables provided.
instrument
for
the
first
time.
Main Menu
2
On start up, the main menu is displayed. All functions may
be accessed directly via the Touchscreen.
System
Select your preferred interface language, date and time
settings and power saving options.
Information
Refer to the complete Operating Instructions. Also find
important device information.
Measurement
Select this option to perform measurements.
Settings
Application specific settings – See Operating Instructions
for details.
Explorer
File manager application for reviewing saved measurements.
PL-Link
3
Install the PL-Link software provided on the DVD. Connect
the instrument to a PC using the USB cable provided. Make
sure you are connected to the Internet.
Click on the PQ-Upgrade icon to check for
software updates.
This action should be performed periodically to make the
most of Proceq's continuous firmware development.
3
Tabla de contenido
