Before Testing; Terms And Conditions Of Warranty - Bahco BBT80 Instrucciones Originales

BEFORE TESTING

1. Before you test a battery in a vehicle, turn off the ignition, all accessories and loads. Close all the vehicle
doors and the trunk lid.
2. Make sure you have put 6 pcs 1.5V batteries into the battery chamber. Oxyride batteries are not
recommended because of the initial 1.7 Volt output. If the 1.5V battery runs out of power, screen will show
"POWER LOW". Replace those 6 pcs 1.5V batteries before starting the test.
Note that nothing will be seen on the display until the tester is connected to a vehicle battery.
3. Make sure the battery terminals are clean. Wire brush them if necessary. Clamp the black load lead to the
vehicle negative battery terminal. Clamp the red load lead to the vehicle positive battery terminal. Please
clamp on the lead part of the terminal only. Clamping on the iron part of the terminal will lead to wrong test
results.
4. Paper load: Open the clear cover. Insert paper to the paper feeding for auto running the paper into printer.
PAPER REPLACEMENT
A. Open the clear cover.
B. Insert replaced paper roll into the paper feeding for auto running the paper into the printer.
C. Pull the paper slowly and straightly from the paper roll in the chamber.

TERMS AND CONDITIONS OF WARRANTY

Any battery tester defective in material or workmanship will be repaired or replaced according to published
defective return test repair procedures. The existence of a defect shall be determined by the seller in
accordance with published procedures. The published test procedures are available upon request.
This warranty does not cover any unit that has been damaged due to accident, abuse, alternation, use for a
purpose other than that for which it was intended, or failure to follow operating instructions. This warranty is
expressly limited to original retail buyers.
This warranty is not assignable or transferable. Proof of purchase is required for all alleged claims. Warranty
cannot be authorized without proof of purchase. Warranty claims must be sent pre-paid with dated proof of
purchase. Damage incurred during shipment is the responsibility of the shipper (customer returning unit) If the
returned unit qualifies for warranty, the shipper will only incur shipping cost. The seller reserves the right to
substitute or offer alternative warranty options at its discretion.
The sole and exclusive remedy for any unit found to be defective is repair or replacement, at the option of the
seller. In no event shall the seller be liable for any direct, indirect, special, incidental, or consequential damages
(including lost profit) whether based on warranty, contract, tort, or any other legal theory.
RETURN GOODS
Pack with sufficient over-pack to prevent damage during shipment. Damage incurred during return shipment is
not covered under this warranty. Repair costs for such damages will be charged back to shipper.
ENGLISH
5