Ryobi LTS180 Manual De Utilización página 7

GB
FR DE ES IT
ASSEMBLY
Depress the spindle lock button, then replace the
wheel screw. Tighten the wheel screw securely by
turning it counterclockwise.
Return the wheel wrench to the storage area.
NOTE: Never use a cutting wheel that is too thick to allow
the outer wheel washer to engage with the fl ats on the
spindle.
SPECIFICATIONS
Voltage
Wheel Diameter
Wheel Arbor
Cutting Depth at 0º
Cutting Depth at 45º
No Load Speed
Wheel Type
Weight (not incl. battery pack)
BATTERY
MODEL PACK
(not included)
BPL-1820
BPL-1815
LTS180
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
OPERATION
WARNING
Always wear a dust mask when operating tile
saws. Failure to do so could result in serious
injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products. Failure
to do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
NL PT DK SE FI NO
English
18 V
102 mm
15.9 mm
22.2 mm
15.9 mm
4,500 min -1
Continuous Rim
Diamond Wheel
2.6 Kg
COMPATIBLE
CHARGER
(not included)
BCL-1800
BCS618
BCL1418
BCL1418
BCL1418
BCA-180
BC-1815S
BC-1800
BCL-1800
BCS618
BCL1418
BCL1418
BCL1418
RU PL CZ HU RO LV
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purposes listed below:
Wet cross cutting, rip cutting, and bevel cutting
of man-made tile, pavers, and natural stone tile
materials.
For dry cutting of the above materials, a special
cutting wheel is required (not provided).
This product will accept Ryobi One+ 18V lithium-ion
battery packs and Ryobi One+ 18V nickel-cadmium
battery packs.
For complete charging instructions, refer to the Operator's
Manuals for your Ryobi One+ battery pack and charger
models.
BATTERY PROTECTION FEATURES
RYOBI 18 V lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximize battery life.
Under some operating conditions, these built-in features
may cause the battery and the tool it is powering to act
differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to stop
running. To reset the battery and tool, release the trigger
and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
INSTALLING THE BATTERY PACK
See Figure 4.
Place the battery pack in the saw. Align the raised rib
on the battery pack with the groove inside the saw,
then slide the battery pack into the saw.
Make sure the latches on each side of your battery
pack snap into place and the battery pack is secured
in the saw before beginning operation.
3
LT EE HR SI SK GR TR