Audio Setup; Radio Operations - Clarion CZ301E Manual De Instrucciones

Audio Setup

Press the [SOUND] button to enter sound
effect setting mode. First press shows
current EQ. Rotate the [VOLUME] knob to
changes BEAT EQ in this order:
OFF -> B-BOOST -> IMPACT -> EXCITE ->
CUSTOM
Rotate the [VOLUME] knob to changes
CUSTOM, and press the [VOLUME] knob,
the press [ ] or [ ] button to select
it including: BAS-G -> BAS-F -> BAS-Q
-> MID-G -> MID-F -> MID-Q -> TRE-G ->
TRE-F, rotate the [VOLUME] knob to select
a value.
BAS-G / MID-G / TRE-G: (-7)- (+7)
BAS-F: 60 / 80 / 100 / 200
BAS-Q: 1.0 / 1.25 / 1.5 / 2.0

Radio Operations

Select tuner as playing source
Press [SRC / ] button once or more to
enter RADIO mode.
Select one radio band
Press the [BAND] button on the panel to
select one radio band among FM1, FM2,
FM3, MW and LW.
Manual tuning
During manual tuning, the frequency will be
changed in steps.
Press the [ ] or [
panel to tune in a higher / lower station.
Auto tuning
Press and hold the [
on the panel to seek a higher / lower station.
To stop searching, repeat the operation
above or press other buttons having radio
functions.
Note:
When a station is received, searching stops
and the station is played.
Preset scan
Preset scan receives the stations stored
in preset memory in order. This function is
useful when searching for a desired station
in memory.
] button on the
] or [ ] button
MID-F: 500 / 1K / 1.5K / 2.5K
MID-Q: 0.5 / 0.75 / 1.00 / 1.25
TRE-F: 10.0K / 12.5K / 15.0K / 17.5K
Press the [SOUND] button, then press [
[ ] button to select USER preset including:
BALANCE -> FADER -> M-B EX -> LPF (low
pass filter) -> S-W VOL (Subwoofer Volume),
rotate the [VOLUME] knob to select a value.
BALANCE: LEFT 1-7->CENTER->RIGHT
1-7
FADER: FRONT 1-7->CENTER->REAR 1-7
M-BEX: ON/OFF
LPF: THROUGH / 80 / 120 / 160
SUBW VOL: (-6)- (+6)
1. Press the [PS/AS] button.
2. When a desired station is tuned in, press
the [PS/AS] button again to continue
receiving that station.
Note:
• Be careful not to press and hold the
[PS/AS] button for 1 second or longer,
otherwise the auto store function is
engaged and the unit starts storing
stations.
Auto store
Only stations with sufficient signal strength
will be detected and stored in the memory.
Press and hold the [PS/AS] button (1 sec.) to
start automatic station search.
To stop auto store, press other buttons
having radio functions.
Notes:
1. After auto store, the previous stored
stations will be overwritten.
2. The unit has 5 bands, such as FM1, FM2,
FM3, MW and LW. FM3, MW and LW can
store by AS function. Each bands can
store 6 stations, CZ301E can store 30
stations in total.
Manual store
When one expected radio station has been
detected, press and hold number button 1-6
to store it in the memory.
] or
10