AL-KO solo 163-55 Traducción Del Manual De Instrucciones Original página 38

en
Check and clean the air filter every day, or after 15 opera-
ting hours at the most.
Turn the choke lever so that it is completely closed,
and keep the carburettor free of dust and dirt.
Loosen the holding bolt (23-1).
Remove the air filter by pulling the air filter cover (on
the filter's rear side) forwards.
If the insert (foam) (23-2) is contaminated with oil,
forcefully press out the insert.
In the case of heavy contamination:
Remove the insert (foam) (23-2), immerse it in hot water or in water and diluted neutral cleaning
–
agent, and then allow the insert to dry fully.
– Clean the insert (felt) (23-3) with petrol, and allow the insert to dry fully.
Let the inserts dry fully before you re-install the air filter. If the inserts are not dried sufficiently,
difficulties in starting the motor may arise.
Use a cleaning rag to wipe off oil adhering around the air filter.
Fit the air filter cover immediately after cleaning, and secure the cover by means of the holding
screw (23-1).
Important points when handling the air filter inserts
Clean the inserts several times per day if excessive dust adheres.
If operation is continued when the inserts are contaminated with oil, oil can leak from the
air filter and result in oil contamination
Checking the spark plug
Check and clean the spark plug after 50 operating hours
at the most.
Use only the supplied Universal bolt spanner to screw
the spark plug in and out.
The separation between the two electrodes of the
spark plug should be between 0.7 and 0.8 mm. Correct
the separation if it is too large or too small. If the spark
plug is affected or contaminated by carbon, clean it
thoroughly or insert a new spark plug. Use only repla-
cement spark plugs of the same type.
Lubrication
Every 50 operating hours, press lubricant grease into the
grease nipple (26-1).
You must comply with the prescribed lubrica-
tion intervals and lubricant quantities.
Otherwise, the machine may be damaged
through insufficient lubrication.
38
(23)
(25)
(26)
Maintenance and care
163-55 / 163-70