Canon FAX-JX500 Guia Del Usuario página 82

RECOMEND NEW CRT
Cause
Ink is low.
REMOVE DOCUMENT
Cause
The document is set while printing.
SET DOCUMENT IN CORRECT POSITION
Cause
The document cannot be correctly
detected or the document is too small.
TAM MEMORY FULL*
Cause
Either 55 messages, including an
outgoing message, alternative
message, voice memos, Fax/Tel
message and forwarding message,
have been recorded or the total
maximum recording time of 30 minutes
has been reached.
* FAX-JX500/JX300 only.
TX/RX CANCELLED
Cause
You pressed [Stop] to cancel the
transmission.
TX/RX NO. nnnn
Cause
When the fax sends or receives a
document, it assigns it a unique
identification number (nnnn).
!!CHECK!! nnnn
Cause
An error requiring servicing might have
occurred.
78 Troubleshooting
Replace the FINE Cartridge (see page 56).
Remove the document. Press [Stop] and try printing again.
Make sure the document meets the requirements and is correctly loaded. If
necessary, reload the document and press [Start]. See "Document
Requirements" on page 15 and "Loading Documents and Paper" on page 16.
Listen to your telephone messages and delete any unnecessary messages.
Alternatively, erase all telephone messages stored in the fax memory (see
page 42).
If required, try sending again.
Write the number down if you will need it later.
Turn OFF the machine, and unplug the power cord of the machine from the
power supply. After a while, plug the power cord of the machine back in and turn
ON the machine. If the same error occurs, contact a Canon service
representative.
Action
Action
Action
Action
Action
Action
Action