Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Stopper
Body
Nut
Rod
Seal Hole
Body
Apply 3 layers of
Tailpiece
sealant tape and
a small bead of
pipe sealant
4. Drain Installation–Style B
- Insert the short end of the rod into the body seal hole and under the
stopper for regular installations. For vandal resistant installations, fit
the rod through the hole in the stopper. Secure with nut.
- Apply 3 layers of sealant tape and a small bead of pipe sealant to the
tailpiece. Thread the tailpiece to the body and tighten securely.
- Slide one end of the clip onto the rod. Slide the link onto the rod
with the thumb screw facing the back of the lavatory.
- Squeeze the other end of the clip, aligning the hole with the rod.
Move the link to the proper position by squeezing the clip and
sliding it along the rod.
- Insert the lift rod into the hole in the faucet and then into the
appropriate hole in the link. The stopper should lift about 3/8"
(1cm) when opened. If necessary, you may bend the link to fit your
installation.
- Tighten the thumb screw on the link so the lift rod knob extends 3"
(7.6cm) from the faucet.
Kohler Co.
Lift Rod
Faucet
Rod
Link
Clip
continued
7
3"
(7.6cm)
Thumb
Screw
A
1015485-2-
Tabla de contenido
