Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HEATER
Heater installation
Once the rear cover of the heater has been removed, connect it to the
installed line that is located on the lower part of the module. The following
figuer shows this connection. For sauna models with Wall Controls.
Place the protective cover back on using the corresponding screws.
Once this step has been completedd, the heater is installed.
Once the manufacturing process is complete, every sauna-booth is
completely assembled and connected for the testing and quality control
phase.
After pasing these, the sauna is dismantled again to be packed. When
disconnecting the heater, the terminal connections not loosened, instead
the cables are cut, keeping one segment of cable hanging form every
terminal with its corresponding colour.
This avoids any possible confusion when connecting the heater upon
assembling the sauna definitively.
The terminals should be loosened to change the hanging ends for the
original cables, ensuring that the colours coincide.
The protective metallic mesh of the lines should remain bolted to the heater
terminal to avoid tugging.
FIG Nº 35
20
18
NEVER FORGET TO CONNECT
THE GROUND, INDICATED WITH
A SYMBOL, TO AVOID
POSSIBLE VOLTAGE
DISCHARGES.
FIG Nº 36
Protective guards for CLASIC, PROFESIONAL and
SELECTE lines.
PROFESIONAL AND SELECTE:
This illustration shows the anchor system and the position that both the
heater and the protective fence should be in to avoid possible contact.
Once the fence is fixed with the 70mm screws, put the granite stones
supplied in place.
FIG Nº 37
17
21
19
Tabla de contenido
