Astralpool WELLMA 1-S Manual De Uso E Instalación página 46

ELECTRICAL CONNECTION
Once the booth is assembled and equipped with accessories, make the
electrical connections between the four keys elements: Thermostat, lamp,
heater and control panel.
From the module that includes all the wiring, two parallel cables RED WHITE
can be seen that pass first through the hole in the upper frame and should be
Re-inserte from the exterior of
the roof through the other,
smaller hole in the roof labeled
THERMOSTAT.
Once the four cables are in
place, connect them to the
sensor terminal strip according
to colour, as indicated in the
figure.
Then, place the wooden
sensor protector in position
and attach it with 30 mm round
head screws.
IMPORTANT:
The electrical installation is channelled completely through the module that
includes the sauna's control panel. In the upper part of this module, the
following can be seen:
1- Flexible cable: 5 network connection threads.
2- Flexible cable: 2 2 lamp connection threads.
3- Parallel cable: 2 strands 1, 5 mm Red-White(Thermostat sensor, Security)
4- Parallel cable: 2 strands 1, 5 mm Red-White (Thermostat sensor,security)
In the lower part the 1- heater is also seen.
All the cables should be passed through the hole in the upper frame of the
front wall before affixing it and, subsequently, the lamp cables (2-) and those
of the temperature sensor (3- and 4-) should be passed through their
corresponding holes in the ceiling.
FIG Nº 29
Lamp connection
CLASIC line and saunas with remote controls for the
heater.
Introduce the flexible cable
through the hole in the
ceiling, as shown in the
figure.
Affix the lamp holders in the
position marked. Uncover
the lamp globe and connect
it as in the diagram. Fasten
the hooks in their marked
positions and hang the
wooden lamp protector.
PROFESIONAL and SELECTE line:
For there, the procedure to follow
is the same as before, but two
wall lamps are supplied. One of
them is the red light and the
other is the white, which has an
intensity regulator.
Although the connection will
usually come already completed,
it must be connected as in the
attached figure. Affix the wall
lamps and holders in the position
marked. For each of therre, the
lamps are supplied with pre-
installed cables.
FIG Nº 30
FIG Nº 31
13