Helvi FOX 165 Manual De Instrucciones página 19

Figure 1
1 4
5
9
Figure 2
10
11
FIG.3
13. Spool holder for wire spools ø 100
and 200mm.
14. 2 Roll Wire Feeder.
15. Polarity Change Terminals for the
Euro Socket:
•
positive polarity for MIG/MAG
Welding,
• negative polarity for No Gas
Welding.
FIG.1
2 3
1.
2.
3.
6
4.
5.
6.
8
7
7.
12
8.
9.
FIG.2
10.
11.
12.
Figure 3
13
Green LED is ON, it means that the unit is powered; it
blinks during start-up or if supply voltage is too high.
Yellow LED ON means over-temperature alarm.
Red LED means Over-voltage or output over-current
alarm.
Welding Mode Selector Switch:
• MMA Welding (Stick);
• automatic MIG/MAG Welding (Mig Auto);
• manual MIG/MAG Welding (Mig Man).
Regulation Potentiometer:
• in MMA, adjusts the value of the welding current;
• in manual MIG/MAG, adjusts the wire speed va-
lue;
• in automatic MIG/MAG, adjusts the value of the
wire speed in accordance to the thickness of the
piece to be welded.
Regulation Potentiometer: • in MMA is not active
• in manual MIG/MAG, adjusts the value of the arc
voltage (no load), ranging from 10 to 25V.in au-
tomatic MIG/MAG, allows the manual adjust of
the welding voltage. Positive socket:
• in MMA, for the connection of the working cable
connector (check for correct polarity for the elec-
trode you are going to use, refer to the informa-
tion on its box). • in "No Gas" MOG Welding for the connection of
the earth cable connector.
Negative socket:
• in MMA for the connection of the earth cable con-
nector (check for correct polarity for the electrode you are going to use, refer to the information on
its box).
• in MIG/MAG Welding for the connection of the
earth cable connector.
Torch
Power Cable.
ON/OFF switch.
Gas Hose connector.
EN-5
15
14