Possible Causes Of Failure - EINHELL TC-HP 1435 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

12. Possible causes of failure

Fault
The equipment
does not work
The motor starts but
there is no pressure
build-up
The operating pres-
sure is irregular
Anl_SA_TC_HP_1435_SPK8.indb 30
Anl_SA_TC_HP_1435_SPK8.indb 30
GB
Cause
- No electrical voltage at the equip-
ment
- The cross section of the extension
cable is not large enough and/or
the extension cable is too long
- The mains voltage is lower than
that specifi ed
- The pump is frozen
- The water intake fi lter is clogged
- Air intake in the water inlet
- The discharge nozzle is too large
- Air intake in the water inlet
- 30 -
Remedy
- Check the fuse, power cable and
power plug and have them replaced
by qualifi ed personnel if necessary
- Use extension cables with larger
cross sections and/or use shorter
extension cables
- Contact the power supply company
if necessary
- Check and thaw if necessary
- Clean the water intake fi lter (see
8.2.1)
- Check the supply hose and hose
connectors and replace if necessa-
ry
- Check and replace if necessary
- Check the supply hose and hose
connectors and replace if necessa-
ry
17.10.2017 08:05:26
17.10.2017 08:05:26

Hide quick links:

Tabla de contenido
loading

Tabla de contenido