Tabla de contenido
VIDEOPORTERO DIGITAL -
INSTRUCCIONES DE CONFIGURACIÓN DE PLACA DE CALLE
ENTRANCE PANEL CONFIGURATION INSTRUCTIONS
DESCRIPCIÓN - DESCRIPTION -
Nota:
Recomendaciones:
To configure the entrance panel, a configuration menu is available. This menu is accessed from the keypad of the entrance panel itself by keying
in the MASTER code. The entrance panel leaves the factory with a default MASTER code which allows access to the menu. It is possible to change
this code inside the configuration menu (Position 19 from the configuration menu).
Note: To prevent outside persons from having access to the menu, we recommend that you replace the default MASTER code by another MASTER
code. You can choose any number between 10000 and 99999.
The menu consists of 19 positions, each of which corresponds to a specific parameter. The
keys will allow you to move through the
different positions. Each position leaves the factory configured with a certain value (default setting), which must be adapted to each particular
installation and to your particular requirements.
Positions 1, 2, 3 and 8 correspond to installation parameters; the value to be selected will depend on the type of installation. The other positions
correspond to user parameters; you can change these setting if the default settings do not suit your needs. Position 18 (Revert to default values)
enables you at any moment to re-establish the default settings of all the positions.
Recommendations:
The system allows you to select from the configuration menu (position 8) the number of digits of the monitor/telephone codes.
Depending on the type of installation, you can choose among several options. Before configuring the entrance panels, it is important that you
decide on the codes that you wish to assign to the monitors/telephones of the installation. This will determine the number of digits that you must
select inside the configuration menu.
.
MASTER
,
-
. MASTER
-
. (
19
).
:
,
MASTER
99999.
19
10000
,
.
:
(
),
.
1, 2, 3 8
,
.
,
,
.
18 (
)
-
.
:
(
8)
/
.
/
,
,
.
Position 1
Value
Position 2
Value
Configuration menu
Tabla de contenido
