Verifying Your Connections; Configuring Routing - Riverbed SteelHead Manual De Instrucciones

Installing SteelHead Product Family Appliances (English)
Plug the crossover cable into the WAN port of the Interceptor and the WAN router.


7. Verifying Your Connections

Check the status lights to verify that the Interceptor is connected properly.

From a remote LAN-side SteelHead, connect to the CLI.

ssh [email protected] or ssh admin@ipaddress
At the system prompt, enter the following ping commands to verify the connections. For example:

ping -I <primary-IP-address> <primary-default-gateway>
ping -I <inpath-IP-address> <address-on-LAN-side>
ping -I <inpath-IP-address> <address-on-WAN-side>

8. Configuring Routing

To connect to the Management Console, enter the URL for the Management Console in the location box

of your Web browser:
http://host.domain or https://host.domain
Create in-path routing rules for every subnet on the LAN-side of the SteelHead Interceptor in the

In-Path Rules page.
Create peer neighbors for each LAN-side SteelHead in Peer Neighbors page.

Verify that the SteelHeads are connected in the Neighbor Peers Report.

22
Installing the Interceptor
Getting Started Guide