Step 8: Installing The Radiator And Fans Assembly Into The Pc Case; Step 9: Pump - Connecting Cables - ekwb EK-AIO 120 D-RGB Manual De Instrucciones

EK-AIO 120 D-RGB UNC 6-32 x 6 mm
(4x)
UNC 6-32 x 6 mm
EK-AIO 240 D-RGB /
EK-AIO 280 D-RGB (8x)
EK-AIO 360 D-RGB
UNC 6-32 x 6 mm
(12x)
STEP 8: INSTALLING THE RADIATOR
AND FANS ASSEMBLY INTO THE PC
CASE
Attach the assembly of the radiator and the
fan(-s) to the PC case with the UNC 6-32 x
6mm screws.
Radiator on top (recommended)
Vertical placement of the radiator with
tubing at the bottom (recommended)
4-pin Connector
D-RGB
Connector
VDG Connector
D-RGB Header
RGB Header
- 7 -
Vertical placement of the radiator with
tubing at the top (not optimal)
Radiator at the bottom (should be avoided)
STEP 9: PUMP – CONNECTING
CABLES
STEP A:
Plug the 4-pin PWM connector of the pump to
the motherboard.
STEP B:
Plug the 3-pin connector of the pump's D-RGB LED
light to the D-RGB HEADER on the motherboard.
The LED will work if the pin layout on the header is
as follows: +5V, Digital, Empty, Ground. With some
motherboards, you can alternatively use a VDG
connector instead of a D-RGB to connect the LED.
Please ensure that the arrow indicated on
the connector is plugged into the +5V line
as indicated on your motherboard. If you
put LED Diode to the 12V RGB HEADER
you can damage the LEDs.
Connector is the same on D-RGB and RGB
versions, but D-RGB version has 3 cables
from connector to PCB; RGB version has
4 cables. If you connect D-RGB led to
ordinary RGB header you can damage
your motherboard or LED strip.