Step 9: Fans - Connecting Cables (Amd); Optional Step! Applying The Thermal Compound; Support And Service; Social Media - ekwb EK-AIO 120 D-RGB Manual De Instrucciones

Fan D-RGB LED Light
Connector
Fan Connector
Fan
Connector
Y-splitter
Fan Connector
D-RGB Header
RGB Header
STEP 9: FANS – CONNECTING
CABLES (AMD)
STEP A:
OPTION 1:
Connect the 4-pin PWM connector of the fan
cable directly to the CPU fan-header on the
motherboard. Always use the CPU fan-header
if possible.
OPTION 2:
In the case of EK-AIO 240 / 280 D-RGB and EK-
AIO 360 D-RGB versions (with 2 or 3 fans), you
may connect the connectors from each of the
fans to the connectors on the Y-splitter cable
and then connect the Y-splitter connector to
the fan-header on the motherboard. Always
use the CPU fan-header if possible.
STEP B:
OPTION 1:
Plug the 3-pin connector for D-RGB LED light
of the fan(-s) to the D-RGB HEADER on the
motherboard.
Non-abrasive
IHS
cloth

7. SUPPORT AND SERVICE

For assistance please contact: http://support.ekwb.com/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU

8. SOCIAL MEDIA

EKWaterBlocks @EKWaterBlocks
ekwaterblocks
EKWBoffi cial
- 11 -
OPTION 2:
In the case of EK-AIO 240 / 280 D-RGB and
EK-AIO 360 D-RGB versions, you may fi rst
connect 2 or 3 fans together in a "daisy-chain"
connection and then connect them all together
to a D-RGB header on the motherboard.
OPTIONAL STEP! APPLYING THE
THERMAL COMPOUND
This step is relevant only in the case of a
second installation of AIO or if you have
damaged the pre-applied paste on the
backside of the pump unit! For the fi rst
installation, you don't need to apply the
additional thermal compound to the CPU's
contact surface!
Wipe the CPU's contact surface (using a
non-abrasive cloth or a Q-tip as shown in the
sample image). On a clean IHS, apply a line
of thermal compound and spread it over the
whole CPU heat spreader (IHS) with a credit
card or something similar.
ekwaterblocks