Product Description And Control Panel; Installation - Klarstein 10029429 Manual Del Usuario

Product Description and Control Panel

1 Switch
2 Display
3 Slide door
4 Shelf
5 Water cabinet
6 ICE FULL sensor
7 Ice storage cabinet
8 Power cord
9 Water inlet connector
10 Screw for drainage
11 Watr outlet connector
12 Foot
Control Panel
1. Remove the appliance from the packaging and remove the protective film from all surfaces.
2. Remove the Ice Spoon, Water Inlet Tube, Water Drainage Pipe and Sealing Washers from the ice storage
cabinet.
3. Place the device on top of an even and safe surface which supports the weight of the device.
4. Choose a surface where the ice maker is not exposed to direct sunlight, or close to a direct source of heat
such as a cooker, oven or radiator.
5. When positioning the ice maker, maintain a distance of 20cm (7 inches) between the appliance and walls
or other objects for ventilation. Increase this distance if the obstacle is a heat source.
6. Position the device in a way so that the power plug is always accessible.
7. Set up the device near water supply connection.
8. If necessary, adjust the screw legs of the ice maker to make it level. The efficiency of the ice maker can be
reduced if the appliance is unevenly located.
9. Connect one end of the Water Drainage Pipe to the water outlet connector on the rear of the ice maker.
10. Attach the other end of the pipe to a plumbed in stand waste pipe or container suitable for collecting
waste water.
11. Connect one end of the Water Inlet Tube to the 3/4" screw type connector of the water tap so as to get the
drinkable tap water. Be sure to put sealing washers in both ends of the water inlet tube before connecting.
12. Connect the other end of the inlet tube to the water inlet connector.
7

Installation