DeWalt DWX726 Manual De Instrucciones página 6

English
ATTACHING THE TOOL (FIG. A, H–K)

WARNING: STABILITY HAZARD. Refer to your tool manufacturer's instructions regarding the securing of your miter saw
to a stand or supporting surface. Secure the tool according to both the instructions in this manual and those in your tool
manufacturer's manual before operating. Failure to heed these warnings may result in serious personal injury and serious
damage to the tool.
1. Turn the stand right side up and leave stand in closed position before attaching the saw.
Fig. H
2. Loosen the 6 rail screws
mounting rails .
1
Fig. I
27
28
27
3. Slide the mounting rails
4. Place miter saw on the mounting rails
(Fig. K).
5. Ensure the mounting holes
6. Insert the mounting bolts/flat washers
Tighten securely.
7. Once the saw is tight to the rails, tighten the rail screws
Fig. J
29
32
4
with the supplied hex wrench. Remove the four mounting bolts/flat washers
27
1
1
1 to fit the width of the tool.
. Center the tool, both forward and backward and side to side, on the stand
1
29 in the tool's feet align with the rail (Fig. J).
(removed in STEP 2) through each of the tool's feet into the captured nut
28
Fig. K
27
27
28
27
27 loosened in STEP 2.
from the
28
27
27
.
32