Safety Rules - DeWalt DWX726 Manual De Instrucciones

English
Definitions: Safety Alert Symbols and Words
This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk
of personal injury or property damage.

DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

(Used without word) Indicates a safety related message.
NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.

SAFETY RULES


WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in personal
injury and serious damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.

WARNING: Failure to follow these rules may
result in serious personal injury.

WARNING: To reduce the risk of injury, keep both
hands on handle when raising and lowering the
stand. The stand has gas assist lifting and may
raise unexpectedly when lever is released.
• This product was designed to be used as a stand for
miter saws. The stand will support up to 300 lbs (136 kg).
Any misuse or abuse can result in product damage or
personal injury.
• Do not stand on the work table. It is unsafe to climb, sit
or stand on the stand. Do not use the support extensions
as a ladder or scaffolding.
• Properly secure the miter saw to the stand before
operation. Follow the mounting instructions carefully.
ASSEMBLY
1. WARNING: PINCH AND IMPACT HAZARD. Do not cut the large securing cable ties (
so later in the manual. The spring loaded mechanism is under tension and can open unexpectedly, with high force. To
reduce the risk of serious personal injury, do not raise or lower stand until the assembly is complete.
Fig. B
34
2
Fasten the tool to the saw mounting rails securely as
instructed.
Place the stand on a flat and level surface to
•
prevent rocking or tipping.
• Take care during the raising and lowering of the
product to reduce the hazard of pinching hands and
fingers.
Check the legs and other supports to see that they
•
are properly locked in place before operation.
• Do not modify or use the stand for any operation
for which it is not intended.
ALWAYS use eye protection. All users and bystanders
•
must wear eye protection that conforms to ANSI Z87.1.

WARNING: ALWAYS use safety glasses. Everyday
eyeglasses are NOT safety glasses. Also use face or
dust mask if cutting operation is dusty. ALWAYS
WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S13.6 (S3.20) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
Fig. B) until instructed to do
34
34